1. Before disassembling the basin faucet, locate the inlet valve. The inlet valve is usually installed on the wall below the basin. 1. First, tighten the angle valve to turn off the water; otherwise, a large amount of water will be wasted during the disassembly of the basin faucet.
2. After tightening the angle valve, some water will remain in the pipe. Turn on the faucet to drain the remaining water.
3. When installing the basin faucet, connect the inlet port of the basin faucet to the angle valve using the inlet hose. When disassembling, hold the water pipe with one hand and turn the wrench with the other to disconnect the end of the inlet hose connected to the basin faucet.
4. During the installation of the basin faucet, the inlet hose is tightened with a nut. Therefore, after removing the inlet hose, locate the fastener of the basin faucet and unscrew it with pliers or a wrench to remove it.
